flow bench calibration
Posted: February 14th, 2007, 9:40 pm
Hi everyone I am new here and ready for my first post.
It may be off subject but I have a home made flow bench which has repeatable results and works well. However I would like to adjust it to get it closer to other machines which I can do quite easily as its sensors are sent to a laptop.
I am always working at 10 inch but would like to find out what size sharp edged orifices flow what on other peoples benches. I can then make my own or borrow and set my own bench accordingly.
Any help would be great thank you
It may be off subject but I have a home made flow bench which has repeatable results and works well. However I would like to adjust it to get it closer to other machines which I can do quite easily as its sensors are sent to a laptop.
I am always working at 10 inch but would like to find out what size sharp edged orifices flow what on other peoples benches. I can then make my own or borrow and set my own bench accordingly.
Any help would be great thank you