flow bench calibration

[superbike]

Hi everyone I am new here and ready for my first post.

It may be off subject but I have a home made flow bench which has repeatable results and works well. However I would like to adjust it to get it closer to other machines which I can do quite easily as its sensors are sent to a laptop.
I am always working at 10 inch but would like to find out what size sharp edged orifices flow what on other peoples benches. I can then make my own or borrow and set my own bench accordingly.
Any help would be great thank you

[Guy Croft]

Phil hi

my SF120 Superflow flows 148.07 cfm at 10" with orifice test plate diameter 1.875", temperature corrected for 12 deg C.

I hope this is helpful,

GC

[1NRO]

With Guy's permission might I post a link that should prove useful?

Nik

[1NRO]

http://www.tractorsport.com/

A lot of knowledge here.

Nik