Race Engine Forum UK

My engine build progresses (slowly)

It a 2.0 T/C from a UK spec 1978 Beta Spider

Before I put it back together permanently I checked the big end and main clearance with plastigage. This is with the new bearings in place. The clearance came out at 0.06mm for both. Looking at the Lancia shop manual that looks fine but my paranoia would like some confirmation.

Also the oil pump gear lobe to lobe clearance is 0.2mm. This is more than specified but experience tells me it will be fine - again some verification would be reassuring.

Thanks.
Stuart

Both those figures are quite typical Stuart and fine. I'd only be concerned at say - 0.075mm (3 thou") on mains.

Gear to casing is more important than backlash - that's the oil pumping route. It isn't actually pumped between the gears, oddly enough.


GC

(BTW after your query I took a load of photos for article on Plastigauge and crank-block checking yesterday but have not done the text yet)

Guy,

Top notch reply.

Re the oil pump thing - it's amazing how much I 'know' because I've assumed it - then I get a reply like that, look at the pump design properly for the first time, and go 'Oh yes, he's right too !'

Many thanks,
Stuart