Page 1 of 1
Sump mod for my Fiat X 1/9 2,0 16V
Posted: March 15th, 2012, 4:02 pm
by torkil
Hi my simple mod. for my X 1/9 . To little oil volum i suppose 3,8 liter in the sump berore it flows over the tray. Have to hold an eye on oil temp!
All hints welcome OVE
- My sump Mod ,Tipo Pan 3,8 liter,
- Sump 2.JPG (106.95 KiB) Viewed 5856 times
Re: Sump mod for my Fiat X 1/9 2,0 16V
Posted: March 17th, 2012, 10:02 am
by Guy Croft
My 1800 Fiat TC big-wing sumps are not much more than 3.8 liters - work OK provided you keep the oil temp down as you say.
Nice of you to show my new book, Ove - thanks for that kind touch!
G
Re: Sump mod for my Fiat X 1/9 2,0 16V
Posted: March 18th, 2012, 11:12 am
by WhizzMan
Is this a hidden challenge? The belt arrangement on that engine in your picture "GC big-wing sump on this 170bhp 1800 TC on 44 IDF" will never work.
Re: Sump mod for my Fiat X 1/9 2,0 16V
Posted: March 18th, 2012, 11:33 am
by TomLouwrier
Oh but it will. ;-)
Re: Sump mod for my Fiat X 1/9 2,0 16V
Posted: March 19th, 2012, 9:58 am
by Guy Croft
It works if you fit the crank front pulley..
in that case a toothed belt drive.
G
Re: Sump mod for my Fiat X 1/9 2,0 16V
Posted: March 25th, 2012, 10:33 pm
by tmvolumex
I agree, the setup will work so long as the custom crank pulley is designed and built to have a proper flange at the back, for guiding the cam belt. As stated elsewhere on this site, you need a flange on both sides of the cam belt. For that matter, the same is a requirement for any toothed belt system, one flange on each side of the belt somewhere in the array of pulleys. For very long belt / pulley arrangements you may need several guiding pulleys. Take a Subaru boxer engine for example.
Tom