Weber DCOE jetting recommendation
Posted: October 15th, 2007, 12:34 am
Hi Guy, fellow forum members.
Im looking for a good starting point in jetting a pair of 45 DCOE (36mm chokes)carbs for use on a 1756 cc twin cam.
The engine has 10:1 compression, 43.5mm inlet valves, and standard 131 brava cams and exhaust header, with 2 inch pipe through to the stock rear muffler at the moment.
Given my supply of jets is limited at the moment can someone please suggest a good starting point for my set up? so im not wasting unnecessary monies and being too far out from what i need.
Thanks
Im looking for a good starting point in jetting a pair of 45 DCOE (36mm chokes)carbs for use on a 1756 cc twin cam.
The engine has 10:1 compression, 43.5mm inlet valves, and standard 131 brava cams and exhaust header, with 2 inch pipe through to the stock rear muffler at the moment.
Given my supply of jets is limited at the moment can someone please suggest a good starting point for my set up? so im not wasting unnecessary monies and being too far out from what i need.
Thanks