Hello Guy and all,
My new chassis has arrived (I'll update my post in readers cars soon) and all is good except I can't find the bearings required for the upper wishbones to pivot on.
Here are the details:
Bore: 0.5"
Diameter: 1.3775"
Width: Free
I was initially looking for Deep Groove Ball bearings until I noticed some Cam Roller type bearings which may better suit the application. Need some help here.
Here is a picture of the upper wisbone. The bearings will need to be pressed into either end of the middle tube.
The wishbones in position
Any help will be much appreciated and if you can supply them as well (Guy), even better.
Regards,
Huw
Imperial roller bearings
-
- Posts: 21
- Joined: June 23rd, 2006, 12:25 pm
- Location: Hertford, UK
- Contact:
Who is online
Users browsing this forum: No registered users and 12 guests