Hi Mr Croft
In my X 19 witch is converted to 2 liter , by using a Croma Turbo block merrid to a 16 V Integrale 16 V head,
I want to convert to 1 inch cam belt old pattern tooth style.
What type off crank pulley will fit . and from what type off engine,I have two early blocks 8v about 1986 year blocks ,
both blocks is fitted with pulley for3/4 belt,old pattern. rear flanged 3 bolt ?
Regards Ove Thorkildsen Oslo
Want to convert my early Croma Block for 1 inch cam belt
-
- Posts: 75
- Joined: December 30th, 2010, 3:10 pm
- Contact:
-
- Site Admin
- Posts: 5039
- Joined: June 18th, 2006, 9:31 am
- Location: Bedford, UK
- Contact:
Re: Want to convert my early Croma Block for 1 inch cam bel
I do not not have a suitable crank pulley for this. I would not do it either, the later generation belt used on the Integrale is prefectly suitable for this application. A superior toothform to the old 3/8" automotive pitch.
There are a few folk who offer a conversion but I would no way get involved in that. There are too many rather 'dodgy 'solutions' for engines 'floating around' that have not been properly designed or executed (made) - for my liking.
G
There are a few folk who offer a conversion but I would no way get involved in that. There are too many rather 'dodgy 'solutions' for engines 'floating around' that have not been properly designed or executed (made) - for my liking.
G
-
- Posts: 75
- Joined: December 30th, 2010, 3:10 pm
- Contact:
Re: Want to convert my early Croma Block for 1 inch cam bel
Thank you Mr Croft For reply . Well then I will fit a 5080 142x18
Regards Ove Thorkildsen Oslo
Regards Ove Thorkildsen Oslo
GC_41
Who is online
Users browsing this forum: No registered users and 10 guests