Page 2 of 2

Re: All ? about 43.5 intake valves in Fiat TC.

Posted: June 10th, 2016, 6:21 pm
by Guy Croft
this is what bothers me Piotr:

"Almost every site about Fiat TC site has a thread about "Big intake valves", "Abarth valves" etc. You must know that some of folks on there sites shares with other a not fully correct info about it, eg. I read on one of Fiat lovers site that you don't need change a smaller valve seats from 41.7mm valves to do this conversion - totally bullshit, I will write about it later..."

This forum is rather unusual in that it is for portrayal of fact not hearsay.

I have never written this before, and never had to. I know the nonsense written on other forums and long-since stopped reading them. I suggest you do the same. And don't use words like bullshit here please, it is not that kind of forum. This site is read by top professionals in the motor industry all over the world.


GC

Re: All ? about 43.5 intake valves in Fiat TC.

Posted: June 10th, 2016, 6:29 pm
by Piotrek125p
According to this nonsense and mess from other sites I wanted to make heare, on the best TC site a thread, where any GC site member can easily get full information about this one of the most popular (in my opinion) operation to make an extra power in Fiat TC engine. Just because in my opinion this site is the best about this engines I decided to make as good as I can thread about this thing.

If I done something wrong, I am very sorry.

Re: All ? about 43.5 intake valves in Fiat TC.

Posted: June 10th, 2016, 6:51 pm
by Guy Croft
it's OK Piotr.

G

Re: All ? about 43.5 intake valves in Fiat TC.

Posted: June 14th, 2016, 5:50 pm
by Piotrek125p
Today I found in my archives a nice photo made by GC about top grind.
Back grind.JPG
Back grind.JPG (54.3 KiB) Viewed 21992 times