Page 1 of 1

Compression Ratio &how to burette ('cc') the head/pistons

Posted: July 7th, 2006, 10:39 am
by Guy Croft
You use a burette to measure fluid volume of combustion chamber and piston dome/valve reliefs. So that you can calculate the compression ratio of the engine (High compression - HC for short might be 9/1, 10/1 or higher, low compression - LC might be 6.8/1, 7.2/1, 8/1 etc).

Any firm that supplies school laboratories can supply a burette, plastic or glass. I use turpentine substitute with a bit of auto trans fluid (ATF) to give colour or paraffin. The plastic plate for measuring is perspex with one fill hole and one air vent, you have to tilt the piston/head slightly to let the air out. The plate has to be stuck/sealed down with grease. If you don't use a plate over the head meniscus effect will spoil your reading, even assuming the fluid doesn't run all over the place.

A domed piston can be cc'd in the bore, just grease around the diameter. The dome is the volume of fluid to fill subtracted from the volume of the cylinder from block deck to piston crown, minus valve reliefs. With a piston with 'bowl' or 'dish' (usually but not always found on supercharged or turbocharged engine) you just stick the perspex plate on top of the piston crown.

The compression ratio (CR for short) is:

CR = 1 + (Vs/Vc)

where Vs is the swept volume of the cylinder
Vc is the clearance volume - the space in the chamber above the piston at TDC

Two Excel calclators are attached, simply put in in the yellow rows the desired CR and bore stroke, etc

GC